Pass4sure ccna 640-802 v2.93

Exam Number/Code: 640-802
Exam Name: Cisco Certified Network Associate

The Introduction to Cisco Networking Technologies exam is one of the two qualifying exams available to candidates pursuing a two-exam option for CCNA. This exam tests content covered in the Introduction to Cisco Networking Technologies (INTRO) course including topics on Network Types, Network Media, Switching Fundamentals, TCP/IP, IP Addressing and Routing, WAN Technologies, Operating and Configuring IOS Devices, and Managing Network Environments. The exam will certify that the successful candidate has important knowledge and skills necessary to describe and identify major network and WAN components, along with their function and purpose

“Cisco Certified Network Associate”, also known as 640-802 exam, is a Cisco certification.
Preparing for the 640-802 exam Searching 640-802 Test Questions, 640-802 Exam, 640-802 Dumps

With the complete collection of questions and answers Q&as with Expert Explanations, Pass4sure has assembled to take you through 245 Q&As to your 640-802 Exam preparation. In the 640-802 exam resources, you will cover every field and category in CCNA helping to ready you for your successful Cisco Certification.

QUESTION 141:
640-802
Www.actualtest.org – The Power of Knowing
The PassGuide network administrator cannot connect to Switch CK1 over a Telnet
session, although the hosts attached to Switch CK1 can ping the interface Fa0/0 of
the router. Given the information shown below and assuming that the router and
Switch2 are configured properly, which of the following commands should be issued
on Switch CK1 to correct this problem?
Exhibit:
A. Switch CK1 (config)# ip default-gateway 192.168.24.1
B. Switch CK1 (config)# interface fa0/1
Switch CK1 (config-if)# ip address 192.168.24.3 255.255.255.0
C. Switch CK1 (config)# line con0
Switch CK1 (config-line)# password cisco
Switch CK1 (config-line)#login
D. Switch CK1 (config)# interface fa0/1
Switch CK1 (config-if)# duplex full
Switch CK1 (config-if)# speed 100
E. Switch CK1 (config)# interface fa0/1
Switch CK1 (config-if)# switchport mode trunk
F. None of the above
Answer: A
Explanation:
To route traffic to other vlans, we need to enter the IP address of the next-hop router
interface that is directly connected to the switch where a default gateway is being
configured. The default gateway receives IP packets with unresolved destination IP
addresses from the switch.
Once the default gateway is configured, the switch will have connectivity to the remote
networks with which a host needs to communicate.
QUESTION 142:
Exhibit:
640-802
Www.actualtest.org – The Power of Knowing
In the PassGuide network segment shown above, host PassGuide A must be able to
telnet to switch PassGuide 1 through router PassGuide 2 for management purposes.
What must be configured or done for this connection to be successful?
A. VLAN 1 on PassGuide 1
B. A default gateway on PassGuide 1
C. A cross-over cable connecting PassGuide 1 and PassGuide 2
D. IP routing on PassGuide 1
E. None of the above
Answer: B
Explanation:
In order for a switch to send traffic to a destination that is not located directly, as is the
case in our example, a default gateway must be configured on the switch. This will
enable it to send the traffic to router PassGuide 2 where it can be routed to host PassGuide A.
Incorrect Answers:
A: This is the default VLAN used and does not need to be configured.
C: A cross over cable is used to connect two switches or two routers together back to
back, but a straight through cable should be used when connecting a switch to a routers.
D: IP routing does not need to be enabled, just the default gateway.
QUESTION 143:
Network topology exhibit:
Output exhibit:
640-802
Www.actualtest.org – The Power of Knowing
You work as a network technician at PassGuide and you issued the arp -a command
from a host named PassGuide A as shown above.
The user of host PassGuide A wants to ping the DSL modem/router at 192.168.1.254.
Based on the Host PassGuide A ARP table that is shown in the exhibit, what will host
PassGuide A do?
A. Send a unicast ARP packet to the DSL modem/router
B. Send a Layer 2 broadcast that is received by Host PassGuide B, the switch and the DSL
modem/router
C. Send unicast ICMP packets to the DSL modem/router
D. Send Layer 3 broadcast packets to which the DSL modem/router responds
E. None of the above
Answer: C
QUESTION 144:
While troubleshooting a connectivity problem, the PassGuide network administrator
notices that a port status LED on a Cisco Catalyst Series switch is alternating
between green and amber. Which condition could this indicate?
A. The port is experiencing errors
B. The port has ac active link with normal traffic activity
C. The port blocked by spanning tree
D. The port is administratively disabled
E. None of the above
Answer: A
640-802
Www.actualtest.org – The Power of Knowing
Explanation: Here are some Port status LEDs
QUESTION 145:
Two PassGuide hosts are connected as shown below:
Ping Exhibit:
640-802
Www.actualtest.org – The Power of Knowing
In the network shown above, a network administrator attempts to ping Host
PassGuide II from Host PassGuide I and receives the results that are shown. What is a
possible problem?
A. TCP/IP is not functioning on Host PassGuide I
B. The default gateway on Host PassGuide I is incorrect
C. The link between Router PassGuide 1 and Router PassGuide 2 is down
D. The link between Host PassGuide I and Switch PassGuide A is down
E. Interface Fa0/0 on Router PassGuide 1 is down
F. The link between Switch PassGuide A and Router PassGuide 1 is down
G. None of the above
Answer: C

Free download:pass4sure 640-802
Free download:PassGuide 640-802

password:www.ciscoexams.org

Bookmark and Share

Download Latest Passforsure P4S Rapidshare links

  1. Free CCNA Official Exam Certification Library (CCNA Exam 640-802) (Exam Certification Guide) Download
  2. Free CCNA Lab 4 Decrypt Router Password Download
  3. Free CCNA Lab 1 Change Router Name and Password Download
  4. Free free Resources Help You To Pass CCNA 640-802 Download
  5. Free CCNA 2 – Module 2 Exam Answers Download
  6. Free Sybex – 640-802 CCNA Study Guide – 6th Edition August 2007(Todd Lammle) Full CD (Includes Ebook, Flash Cards, Videos & Test-Engine) Download
  7. Free PassGuide ccna 640-802 v2.93 Download
  8. Free pass4sure ccna 640-822 v2.93 Download
  9. Free free pass4sure ccna 640-802 v3.10 Download
  10. Free Ciscopress CCNA Video Mentor (Exam 640-802) Download
  11. Free the latest PassGuide ccna 640-802 v3.10 Download
  12. Free CCNA Lab 2 Set Router Port Address/Label and Save Settings Download
  13. Free free p4s cisco ccna 640-802 v2.95 Download
  14. Free pass4sure ccna 640-816 v2.93 Download
  15. Free 5 CCNA Certification Exam Dumps Download
latest pass4sure

8 Responses to “Pass4sure ccna 640-802 v2.93”

  1. mbkmbgmbgkmgkhkgf

  2. pass4sure says:

    p4s ccna 802 latest crack version

  3. Anonymous says:

    dgbghh bfgg

  4. abdallah says:

    hi all plz i want the latest p4s for new ccna

  5. mohamed says:

    thanks

  6. zeko says:

    thank u alot for this

  7. pass4sure says:

    Product Description Introduction

    Exam Number/Code: 640-802
    Exam Name: Cisco Certified Network Associate

    “Cisco Certified Network Associate”, also known as 640-802 exam, is a Cisco certification. Preparing for the 640-802 exam Searching 640-802 Test Questions, 640-802 Exam, 640-802 Dumps

    With the complete collection of questions and answers Q&as with Expert Explanations, Pass4sure has assembled to take you through 254 Q&As to your 640-802 Exam preparation. In the 640-802 exam resources, you will cover every field and category in CCNA helping to ready you for your successful Cisco Certification.

    Questons and Answers : 254 Q&As
    Updated: 3/18/2008
    Version: 2.95 Latest

    System Requirements
    Download Java

    Code:

    http://w13.easy-share.com/1700103781.html

    Dumps

    Code:

    http://w15.easy-share.com/1700160475.html

Leave a Reply